Dpc-1000/BW 1501-4 combo

[Will Aytes]

Does anyone on the forum have experience with the Peavey DPC-1000 being used with Peavey Black Widow 1501-4 speakers? With steel of course. Just need an experienced hand here to give me the yes's and no's or do not's. Give me some of your experienced thought before I go experimenting. PLEASE

Thanks for your help up Front
Will

------------------
MSA D-12 8&5 , Transtube Fex, Nashville 400, Session 500, New Mullen HWP D-10 on order

[Len Amaral]

I use the Peavey DPC-1400 that is basically the same amp with more power with the 1501-4 speakers. You didn't mention what preamp or preamp/processor you are using with this setup?

The DPC-1000 with the 1501-4 speakers should work just fine.

[Paddy Long]

I have used the DPC750 with 2 Nashville E115 - 1501-4 for about 8 or 9 years and it is a fabulous setup -- along with the a Profex II it is hard to beat.

[Will Aytes]

Thanks for the response. I am using a Transtube Fex along with the DPC-1000 into my hand made cabinets for my BW 1501-4 speakers. I make my cabinets similar to the Marrs cabinets.

Thanks
Will

------------------
MSA D-12 8&5 , Transtube Fex, Nashville 400, Session 500, New Mullen HWP D-10 on order

[Mike Brown]

Will, as long as you adhere to proper operation of the DPC amplifier, ie; DDT compression feature, there should not be any problems.

However, if you have questions, I can be reached here at the factory today only and after Monday of next week. Beginning tomorrow, I will be traveling to the TSGJ in Irving, Texas. Hope to see you there.

In the meantime, I can be reached toll free in North America at 1-877-732-8391.

Mike Brown
Peavey Electronics Corporation

[Will Aytes]

Thanks everyone for your greatly appreciated comments. I have purchased a DPC-1000 feelin more comfortable doing so with helpful comments from the forum members.

Again
Vast Appreciation to ya'll

Will

------------------
MSA D-12 8&5 , Transtube Fex, Nashville 400, Session 500, New Mullen HWP D-10 on order