? for Mike Brown

[Bosse Engzell]

Can I get my ProFex I to sound like a Dobro? if yes, How to program the ProFex?
Bosse in Sweden

[Bill Crook]

Check out Factory pre-set A113...

(Oh,I see that you are useing a "Profex I".)
I'm not too sure about the setting on this one. I'm useing a "Profex II".


Smiley Roberts and I use this on a number of occasions and it's as close to a Drobro as I can get !!

Smiley's really good with it but I sound like a cat in heat,or perhaps something much worst.

Bill


<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Bill Crook on 03 July 2003 at 11:40 AM.]</p></FONT>

[Mike Brown]

I've never had the chance to program a Dobro voicing into the original Profex, but from the effects that are used in the Profex II version, it looks as if can be done. I don't have an original Profex unit to try this with, but here are the parameters for each effect that is used for our Dobro preset;
3B+CM+RV+DL

"3B"
TYPE-GUITAR
LOW-+11
MFrq-570 Hz.
Mid-(-42)
Hi-+21
OUTPUT-100

"CM"
Atk-Slow
Rel-X Fast
Sus-5
Lev-10%
NG Thr-10
OUTPUT-67

"RV"
Ty-PLATE
Sz-LARGE
PDly-30ms
Time-2.9s
Damp-8kHz.
MX-100%
OUTPUT-13

"DL"
Type-STEREO
L.Dly-75ms
L.Fbk-17%
R.Dly-150ms.
R.Fbk-17%
TAPE SIM-1K
Mix-STEREO
OUTPUT-10

Hope that this helps you out. Let me know if you are successful in programming this effect into the original Profex as I don't have this particular product to try this on.

Mike Brown
Peavey Electronics Corporation

[b0b]

moved to 'Electronics'