nashville 400 problem

John Robel · Post by **John Robel** » 14 Dec 2009 8:02 pm

I havent used my nashville 400 in a while and it worked great when I put it away. I plugged it in and it pops and squeals at random,just sitting there. Sometimes I can play my steel through it and its fine,then it starts to pop and squeal and I hear reverb in the aftermath. Any one have similar problems? Thanks, John

Tony Prior · Post by **Tony Prior** » 15 Dec 2009 1:40 am

clean the 1/4 connectors on the rear and you may have to pull the chassis and clean all the MOLEX connectors, including the reverb connector. This is a common issue with these amps. Dirty connections, start with the 1/4 jacks on the rear panel.

good luck

t