Fender badge on Stringmaster

Alex Cattaneo · Post by **Alex Cattaneo** » 20 Sep 2024 4:55 am

Time to re-attach the Fender logo on my Stringmaster. When I got the guitar, this was attached to the front of the guitar, where the decal usually goes! I know where to set it from pictures, but I was wondering if these are the right screws? Maybe someone knows (Tony Oresteen?) or could post some some close-up pictures of the badge on their unmolested Stringmaster.

Nathan Laudenbach · Post by **Nathan Laudenbach** » 20 Sep 2024 6:04 am

For what it’s worth, the badge on my Dual Pro is attached with small nails.

Miles Lang · Post by **Miles Lang** » 20 Sep 2024 6:25 am

Small nails on my ‘66 Stringmaster

Joe Burke · Post by **Joe Burke** » 20 Sep 2024 6:48 am

Looks like right in the middle on mine.

Joe Burke · Post by **Joe Burke** » 20 Sep 2024 6:49 am

Chris Clem · Post by **Chris Clem** » 20 Sep 2024 8:42 am

They are called Escutcheon pins. They come in many sizes,Nickel plated or solid Brass etc......They are cheap on Ebay or any hardware supply . The key is figuring out the size you need. It should go into the wood about 1/2 inch. Pre-drill the hole just slightly smaller then the shaft size.

Alex Cattaneo · Post by **Alex Cattaneo** » 20 Sep 2024 9:49 am

I knew those screws looked wrong!

Thanks guys!

Per Berner · Post by **Per Berner** » 20 Sep 2024 10:29 am

Looks like the holes on your badge have been enlarged (to fit the screws). Might make it difficult to fit the badge using the pins, which look a lot smaller anc may not cover the holes.