Fatfinger

Keith Cordell · From: San Diego

Has anyone else used one of these on a lap steel? I have been using one for increased sustain on my Curlee guitar for years, and just for grins and giggles put one on my new/old Gibson Royaltone, and it beefed up the sustain on open notes considerably. Has this been discussed before?

------------------
Gibson Royaltone, Sierra S8, bakelite bars
Pedals are for bicycles!

Mark van Allen · From: Watkinsville, Ga. USA

Yeah, Keith, there was a thread about this a while back. I haven't found it with a quick look, but it's lurking somewhere. Also a thread about solid brass peghead overlay...

------------------
Stop by the Steel Store at: www.markvanallen.com

[This message was edited by Mark van Allen on 21 March 2005 at 10:10 AM.]

Jeff Strouse · From: Jacksonville, Florida, USA

http://steelguitarforum.com/Forum2/HTML/001813.html

Keith Cordell · From: San Diego

Thanks Jeff! I can tell a distinct difference when I use it and am quite happy to have found all that discussion about it. It's been a while since it was talked about, so I don't feel too bad about bringing it up again.

Ron Whitfield · From: Kaaawa, Hawaii, USA

Years ago I had an 1/8" plate machined to accomodate the backside of my Rick B8, just out of curiousity stemming from the late 80s adds of this type procuct.

Suprisingly, I didn't notice a difference when it went on or when it came off 5 years later.

Forum Index > Steel Without Pedals		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: