Emmons Pickup Height Adjusting Screws

Benjamin Franz · From: Melbourne, Victoria, Australia

Can anyone tell me the size/thread for the pickup height adjusting screws on this 1971 Push Pull? Two of them rattled loose in the case and were lost on stage as the guitar was removed from the case. Thanks in advance.

Kelcey ONeil · From: Sevierville, TN

They are 6-32 thread size, and 3/4 of an inch long.
There should also be a piece of spring about 3/8 long between the neck and pickup plate.
_________________
Co-owner and operator: Emmons Guitar Co.

Benjamin Franz · From: Melbourne, Victoria, Australia

Thank you Kelcey. Much appreciated. I was aware of the springs.

George Duncan Sypert · From: Colo Spgs, Co, USA

What would the proper distance between bottom of the strings and top of the poles on the pickup?

Richard Vogt · From: Iowa, USA

Any one have a pick-up plate that they would like to sell or know where I could buy one for Emmons PP.Thank you Richard Vogt. e-mail dgerry2@msn.com or call me at
515)7788682

Ron Funk · From: Ballwin, Missouri

George asked -

"What would the proper distance between bottom of the strings and top of the poles on the pickup?"

The old rule of thumb was the thickness of a US quarter.

Hope that helps -
Ron

Richard Vogt · From: Iowa, USA

Found one.

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: