| Author |
Topic: Sierra s10 pedal stop |
Alan Cook
From:
Kent,England
|
Posted 19 Nov 2022 10:35 am |
|
Can anyone tell me the thread size and length of the pedal stop cap head screw?
 ? |
|
|
|
Alan Cook
From:
Kent,England
|
Posted 20 Nov 2022 4:48 am
|
|
The screw on pedal C has snapped off and the stub is still in there, you can see the ones on pedal A&B with the lock nuts in place. It's very close to 4mm but I guess it's an imperial size not metric! Any help would be great.
Alan. |
|
|
|
Barry Coker
From:
Bagley Alabama, USA
|
Posted 20 Nov 2022 5:14 am
|
|
I'm guessing here the stop screw is 10-32. 4.763mm is 3/16 Imperial which would be the standard hole drilled for a 10-32 screw to drop through. Which would mean the screw would be very close to 4mm.
Jim Palenscar here on the forum would be the person to contact.
Good luck
Barry
_________________
Zum-D-10, Webb 614-E, 65 Pro Reverb, Evans RE200, 69 Gibson Birdland, 89 Telecaster EAD Bad!! |
|
|
|
Patrick Timmins
From:
Seattle
|
Posted 20 Nov 2022 2:50 pm
|
|
I just measured an early 90s Sierra Session I have in the shop and the diameter is for a #8 screw. Mine does not have any jam nut, or lock nut in place, so yours may differ. It could be an 8-32 or an 8-36. Likely 36 teeth per inch (UNF) for fine tuning.
If you can get some calipers to measure, here is an ANSI/ASTM thread chart for all classed screws.
https://www.engineersedge.com/screw_threads_chart.htm
Patrick.
_________________
Microphones, Recording, and lots of pedal steel guitars! |
|
|
|
Alan Cook
From:
Kent,England
|
Posted 21 Nov 2022 12:38 am
|
|
| Thanks guys I'll check it out. |
|
|
|
Alan Cook
From:
Kent,England
|
Posted 21 Nov 2022 2:03 pm
|
|
It was an 8/32 .160" dia 32 tpi had to drill out the broken one and re tap. All done and working, thanks again for the help.
Alan |
|
|
|
