| Author |
Topic: Rickenbacher Panda Bridge and knob help. |
Lloyd Walsh
From:
San Antonio, Texas, USA
|
Posted 20 May 2022 12:15 pm |
|
I'm still a rookie on this forum/site and if i'm posting in the wrong spot please direct me and delete this.
currently i'm negotiating a purchase on eBay for what i'm guessing is either a war-time or post war-time Panda. It's missing the bridge and a knob, is there a source to get replacements that anyone knows of (especially the bridge!)?
Thanks!!
 |
|
|
|
Jack Hanson
From:
San Luis Valley, USA
|
Posted 20 May 2022 12:59 pm
|
|
| You can get nice reproduction flying saucer knobs from Todd Clinesmith, and George Piburn sells good repro bridges. |
|
|
|
Lloyd Walsh
From:
San Antonio, Texas, USA
|
Posted 20 May 2022 2:26 pm
|
|
Thank you Jack! I’ll go over there for the knob.
Anyone know of a bridge?
I saw an older thread where someone had one fabricated but i don’t even have one to copy.
Thanks! |
|
|
|
Jack Hanson
From:
San Luis Valley, USA
|
Posted 20 May 2022 4:16 pm
|
|
| Lloyd Walsh wrote: |
Anyone know of a bridge?
|
Repro Ric bridges are available from Georgeboards. (I have one; it's nice.) Scroll to almost the bottom of the page until you reach this heading:
3D Printed Nut and Bridge Fits Ricky NS -100 -105 - pandas for Upgrade and DIY Builds GeorgeBoards™
https://www.georgeboards.com/parts.html |
|
|
|
Lloyd Walsh
From:
San Antonio, Texas, USA
|
Posted 20 May 2022 7:30 pm
|
|
| Thanks again for all your help..!! |
|
|
|
