| Author |
Topic: Emmons pp pull rods |
Tom Higgins
From:
New Jersey, USA
|
Posted 17 Nov 2021 11:07 pm |
|
| Hi,is there a source for these? I need a couple of long ones for C6`th pedal raises.Not pedal rods,the bellcrank to changer ones.My guitar is from 1970. Thanks. |
|
|
|
Lynn Stafford
From:
Ridgefield, WA USA
|
Posted 18 Nov 2021 11:34 am Emmons pp pull rods
|
|
Tom,
Do you have a welding supply store nearby? If so, they sell 1/8" diameter by 36" long stainless welding rod. I usually buy 308 series alloy, if I remember correctly and it's fairly inexpensive. The brand I bought had the series stamped on a flat on each end. Those flats are handy for drilling a hole for raise hooks to use for pull rods.
_________________
Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
Tom Higgins
From:
New Jersey, USA
|
Posted 18 Nov 2021 9:58 pm
|
|
| Thanks,Lynn,I`ll look into that. |
|
|
|
Jim Sliff
From:
Lawndale California, USA
|
Posted 22 Nov 2021 4:25 pm
|
|
Also contact Kelcey O'Neil at Emmons Guitar company - they are making Push Pulls again, and may have parts available. If not, they'll certainly know where to get the right ones!
http://www.emmonsguitar.co/
_________________
No chops, but great tone
1930's/40's Rickenbacher/Rickenbacker 6&8 string lap steels
1921 Weissenborn Style 2; Hilo&Schireson hollownecks
Appalachian, Regal & Dobro squarenecks
1959 Fender 400 9+2 B6;1960's Fender 800 3+3+2; 1948 Fender Dual-8 Professional |
|
|
|
