| Author |
Topic: Quilter TT15 Volume issue. |
Bobby Hearn
From:
Henrietta, Tx
|
Posted 3 Sep 2021 8:16 pm |
|
| Just wondering if anyone has had any issues with volume. I played a job tonight and had master and gain maxed out and it was adequate but I’m thinking it should have been way louder at those levels. On my Steelaire I max master and run the gains at 4 at the most. |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 4 Sep 2021 2:15 am
|
|
My TB202 has more volume than I need.
Were you using any effects? or maybe a problem with the volume pedal.
Try it with just guitar to amp first and see if you have full volume. If OK then add volume pedal and try again. If OK, add whatever effects and try again. If everything is OK it could have been a bad guitar cord connection somewhere in the chain or even low AC power voltage.
_________________
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit |
|
|
|
Bobby Hearn
From:
Henrietta, Tx
|
Posted 4 Sep 2021 5:44 am
|
|
| Thanks Jack, gonna do some checks today and see what I come up with. |
|
|
|
Al Evans
From:
Austin, Texas, USA
|
Posted 4 Sep 2021 5:58 am
|
|
| Bobby Hearn wrote: |
| Thanks Jack, gonna do some checks today and see what I come up with. |
Maybe a dumb question, but how about the limiter? You didn't mention that....
--Al Evans
_________________
2018 MSA Legend, 2018 ZumSteel Encore, 2015 Mullen G2, G&L S-500, G&L ASAT, G&L LB-100, Godin A4 Fretless, Kinscherff High Noon |
|
|
|
Bobby Hearn
From:
Henrietta, Tx
|
Posted 8 Sep 2021 9:54 am
|
|
| Al, this amp is still new to me and I’m not sure what the limiter does and it doesn’t seem to make any difference. The instructions do say it’s subtle but a lot of the instructions seem to be explained to another sound engineer and not an electronics dummy like myself. |
|
|
|
Jon Light
From:
Saugerties, NY
|
Posted 8 Sep 2021 10:06 am
|
|
| The limiter will NOT have a noticeable affect on the volume, no matter how it is set. Its subtle impact is on hair/overdrive/'sag' when the gain is turned up. |
|
|
|
Al Evans
From:
Austin, Texas, USA
|
Posted 9 Sep 2021 5:41 am
|
|
| Jon Light wrote: |
| The limiter will NOT have a noticeable affect on the volume, no matter how it is set. Its subtle impact is on hair/overdrive/'sag' when the gain is turned up. |
OK. I have assumed that, as a limiter, it would limit the maximum signal passing out of the preamp to the power amp. But I haven't tried it at high volume levels.
--Al Evans
_________________
2018 MSA Legend, 2018 ZumSteel Encore, 2015 Mullen G2, G&L S-500, G&L ASAT, G&L LB-100, Godin A4 Fretless, Kinscherff High Noon |
|
|
|
Bobby Hearn
From:
Henrietta, Tx
|
Posted 10 Sep 2021 4:09 pm
|
|
| Do yo plug into the 4 ohm or the 8 ohm Jack? |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 11 Sep 2021 2:27 am
|
|
| Bobby Hearn wrote: |
| Do yo plug into the 4 ohm or the 8 ohm Jack? |
The TT 15 is 4 ohms.
_________________
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit |
|
|
|
Malcolm McMaster
From:
Beith Ayrshire Scotland
|
Posted 14 Sep 2021 12:20 am
|
|
Bobby, some of us had problems with volume on Steelaire, lots of previous posts on this.
_________________
MSA Millenium SD10, GK MB200, Sica 12inch cab, Joyo American Sound Pedal/ Jay Ganz Straight Ahead amp, Telonics 15inch in Peavey cab, Digitech RP150, Peterson tuner.Hilton volume pedal.Scott Dixon seat and guitar flight case. |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 14 Sep 2021 2:05 am
|
|
| Malcolm McMaster wrote: |
| Bobby, some of us had problems with volume on Steelaire, lots of previous posts on this. |
This thread is not about a Steelaire volume problem. The TT15 uses the Quilter TB202 amp.
_________________
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit |
|
|
|
Malcolm McMaster
From:
Beith Ayrshire Scotland
|
Posted 14 Sep 2021 2:33 am
|
|
Jack, I am well aware what the post subject is.I am pointing out to OP that there have been volume problems with other Quilter products.
_________________
MSA Millenium SD10, GK MB200, Sica 12inch cab, Joyo American Sound Pedal/ Jay Ganz Straight Ahead amp, Telonics 15inch in Peavey cab, Digitech RP150, Peterson tuner.Hilton volume pedal.Scott Dixon seat and guitar flight case. |
|
|
|
Travis Toy
From:
Nashville, TN, USA
|
Posted 8 Oct 2021 6:58 pm Re: Quilter TT15 Volume issue.
|
|
| Bobby Hearn wrote: |
| Just wondering if anyone has had any issues with volume. I played a job tonight and had master and gain maxed out and it was adequate but I’m thinking it should have been way louder at those levels. On my Steelaire I max master and run the gains at 4 at the most. |
Bobby, did you get this figured out? With master and gain both turned all the way up, it should be insanely loud. Like, you shouldn't be able to stand to be anywhere near it.
-t
_________________
www.travistoy.com
www.travistoytutorials.com |
|
|
|
Michael Stephens
From:
South Hadley, MA
|
Posted 9 Oct 2021 2:21 am
|
|
| Have you contacted Pat Quilter? He's been very responsive (as in less than 24 hrs) to every question I"ve put to him about my Quilter TT12. |
|
|
|
