Author |
Topic: WTB: Emmons P/P tuning screw |
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 3 Jan 2021 4:43 pm
|
|
Hey guys, I would like to buy (1) Push-Pull fine tuning screw. In my area, things like this are almost impossible to find. Any help, greatly appreciated. Eddie |
|
|
|
Roger Crawford
From: Griffin, GA USA
|
Posted 3 Jan 2021 5:11 pm
|
|
Eddie, check with Billy Knowles. He’s here on the SGF and FB. |
|
|
|
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 3 Jan 2021 5:32 pm
|
|
Thanks Roger! |
|
|
|
Ron Funk
From: Ballwin, Missouri
|
Posted 5 Jan 2021 8:22 pm
|
|
Eddie -
You might want to consider removing one of the existing fine tuning screws that is Not affected by Either a Raise or Lower (without knowing your setup, say, perhaps your 7th string?)
Then find an Ace Hardware aisle and ask 'can you match this? '
Just a thought
Or not
Ron |
|
|
|
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 5 Jan 2021 9:32 pm
|
|
Thanks Ron! |
|
|
|
Ron Funk
From: Ballwin, Missouri
|
Posted 5 Jan 2021 10:12 pm
|
|
Make sure you check both yours and the one they give you in their ‘thread-o-meter’ |
|
|
|
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 5 Jan 2021 11:41 pm
|
|
Thanks! |
|
|
|
Tony Glassman
From: The Great Northwest
|
Posted 6 Jan 2021 9:09 am
|
|
Emmons guitars use Nylok tipped socket cap screws, which are not typically found In hardware stores. This is to hold the tuner screw in place while playing. McMaster-Carr, Billy Knowles or Lynn Stafford may sell them.
If you go the non Nylok route, you’ll need to put a small spring on the screw before screwing it in to help it hold pitch.
I can’t remember the screw size but I’ll check later on my “thread-o-meter†and get back to you. |
|
|
|
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 6 Jan 2021 9:21 am
|
|
Thanks Tony! |
|
|
|
Larry Moore
From: Hampton, Ga. USA
|
Posted 17 Jan 2021 9:07 pm PP tuning Screw
|
|
Eddie I have several 6-32-7/8 long coated with Red locktite.
If you have not found any send me address.
I can make you a deal.
Larry Moore
lmoore40@bellsouth.net
|
|
|
|
Clyde Mattocks
From: Kinston, North Carolina, USA
|
Posted 18 Jan 2021 9:50 pm
|
|
Another route if you can't find the nylok one,put just a dab of contact cement on the thread. _________________ LeGrande II, Nash. 112, Harlow Dobro |
|
|
|
Eddie Thomas
From: Macon,Ga.,USA
|
Posted 19 Jan 2021 1:55 am
|
|
Thanks Clyde! |
|
|
|