Author |
Topic: reverb on nv1000 |
Mike Bowles
From: Princeton, West Virginia, USA
|
Posted 9 Jan 2019 12:11 pm
|
|
the reverb on my nv1000 stopped working changed the cable how do you check the tank? _________________ Mike Bowles |
|
|
|
Stephen Cowell
From: Round Rock, Texas, USA
|
Posted 12 Jan 2019 9:26 pm
|
|
Divide and conquer... first, turn up the reverb some, then shake the tank... noise? If not, then the pickup/circuit is bad... if OK, then your problem is in the reverb drive. Make sure you don't have it switched off with a footswitch etc. You can ohm the tank transducers... one of them is typically lower than the other, that's the input (driven) side. If one side's open, you need a new tank. Check the cables... make sure the cables aren't reversed. Do you own a voltmeter? _________________ New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329 |
|
|
|
Mike Bowles
From: Princeton, West Virginia, USA
|
Posted 13 Jan 2019 10:17 am reverb
|
|
thanks when i hit the top of the amp it boings had the tank out didnt see anything yes i have an ohm meter and volt meter. thanks again. _________________ Mike Bowles |
|
|
|