reverb on nv1000

Mike Bowles · From: Princeton, West Virginia, USA

the reverb on my nv1000 stopped working changed the cable how do you check the tank?
_________________
Mike Bowles

Stephen Cowell · From: Round Rock, Texas, USA

Divide and conquer... first, turn up the reverb some, then shake the tank... noise? If not, then the pickup/circuit is bad... if OK, then your problem is in the reverb drive. Make sure you don't have it switched off with a footswitch etc. You can ohm the tank transducers... one of them is typically lower than the other, that's the input (driven) side. If one side's open, you need a new tank. Check the cables... make sure the cables aren't reversed. Do you own a voltmeter?
_________________
New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329

Mike Bowles · From: Princeton, West Virginia, USA

thanks when i hit the top of the amp it boings had the tank out didnt see anything yes i have an ohm meter and volt meter. thanks again.
_________________
Mike Bowles

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: