| Author |
Topic: MSA Millenium Legs |
Frank Krevens
From:
New York, USA
|
Posted 13 Nov 2018 7:08 am |
|
Recently the rear adjustable legs on my MSA have lost their ability to stay at the desired height. They just keep lowering themselves. Anyone have any suggestions on how to remedy this? The legs are carbon fiber btw.
Any input would be helpful. Thanks! |
|
|
|
Ross Shafer
From:
Petaluma, California
|
Posted 13 Nov 2018 7:32 am
|
|
| I'm sure the good folks at MSA could help you. |
|
|
|
Sonny Jenkins
From:
Texas Masonic Retirement Center,,,Arlington Tx
|
Posted 13 Nov 2018 8:56 am
|
|
| A wooden dowel would keep them at a fixed height. You could switch front/rear and have fixed front,,,adjustable rear. |
|
|
|
Bobby D. Jones
From:
West Virginia, USA
|
Posted 13 Nov 2018 7:53 pm MSA Millentium legs.
|
|
You can put dowel rods in 2 ways, If that is what you chose.
First you can fit a piece of dowel rod that just fits in the outer sleeve of the leg and the inter part will stop when it hits the dowel rod. Takes a little figuring to get the rod the exact length you want.
The second way is remove the rubber foot from the leg and run a dowel rod that fits the inside of the smaller inter leg. Run it till it hits solid on the threaded stud that screws into the guitar, Then cut it off even with the end of the leg and put the rubber foot back on. You will not be able to shorten a back leg to get the guitar to set solid either way, But you can lengthen one of the back legs to get the guitar to set solid on a bad floor.
Good Luck on a cure, And Happy Steelin. |
|
|
|
