Author |
Topic: JCH Parts |
Joe Swierupski
From: Asheville, NC
|
Posted 11 Jul 2018 9:15 am
|
|
Hey all,
I have a beautiful JCH on the bench here and I'm looking for the a bell crank for it. They actually look somewhat similar to a GFI bell crank and rod kit. Can anyone with a GFI do some measuring for me?
I'm looking for the width of the cross-rods the bell cranks are attached to.
Or... is anyone sure that a GFI Bell Crank would work/not work?
If it wouldn't work, any suggestions?
Thanks up front!!! |
|
|
|
Lynn Stafford
From: Ridgefield, WA USA
|
Posted 11 Jul 2018 9:28 am JCH Bell Cranks
|
|
Joe,
Emmons 4-hole bell cranks resemble JCH bell cranks, except for the holes being staggered. They will fit on the square cross bars and the JCH swivels will also fit the 1/4" holes, or visa versa. _________________ Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
Joe Swierupski
From: Asheville, NC
|
Posted 11 Jul 2018 11:05 am Re: JCH Bell Cranks
|
|
Lynn Stafford wrote: |
Joe,
Emmons 4-hole bell cranks resemble JCH bell cranks, except for the holes being staggered. They will fit on the square cross bars and the JCH swivels will also fit the 1/4" holes, or visa versa. |
Thanks so much for the info, Lynn! |
|
|
|
Tony Dingus
From: Kingsport, Tennessee, USA
|
Posted 11 Jul 2018 6:43 pm
|
|
When I had my JCH I used a Emmons bellcrank. Worked great.
Tony |
|
|
|
Paddy Long
From: Christchurch, New Zealand
|
Posted 11 Jul 2018 7:26 pm
|
|
I think the GFI crossshafts are smaller !! _________________ 14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases. |
|
|
|
Joe Swierupski
From: Asheville, NC
|
Posted 12 Jul 2018 10:23 am
|
|
Paddy Long wrote: |
I think the GFI crossshafts are smaller !! |
I thought as much, but I thought I'd check. Thank you!! |
|
|
|