
MSA Millenium -- a review...
Moderator: Dave Mudgett
-
Paul Warnik
- Posts: 1847
- Joined: 1 Mar 2001 1:01 am
- Location: Illinois,USA
- State/Province: Illinois
- Country: United States
-
Harry Hess
- Posts: 1131
- Joined: 29 Mar 2000 1:01 am
- Location: Blue Bell, PA., USA * R.I.P.
- State/Province: -
- Country: United States
-
Donny Hinson
- Posts: 21790
- Joined: 16 Feb 1999 1:01 am
- Location: Glen Burnie, Md. U.S.A.
- State/Province: -
- Country: United States
Actually Harry, the front and rear aprons are much less than that! I measured them at about .170", a little less than 3/16". Other than the endplates and nameplate, though, nothing is affixed to them. All the crossrods are mounted via heavy bronze bushings to an aluminum carriage that is screwed to the underside of the body (which is far more substantial).<SMALL>I grabbed the cabinet and was amazed that it was only about a 1/4 of an inch thick, 3/8's tops.</SMALL>
-
Harry Hess
- Posts: 1131
- Joined: 29 Mar 2000 1:01 am
- Location: Blue Bell, PA., USA * R.I.P.
- State/Province: -
- Country: United States
-
Bobby Lee
- Site Admin
- Posts: 14863
- Joined: 4 Aug 1998 11:00 pm
- Location: Cloverdale, California, USA
- State/Province: -
- Country: United States
-
Earnest Bovine
- Posts: 8368
- Joined: 4 Aug 1998 11:00 pm
- Location: Los Angeles CA USA
- State/Province: -
- Country: United States
-
Donny Hinson
- Posts: 21790
- Joined: 16 Feb 1999 1:01 am
- Location: Glen Burnie, Md. U.S.A.
- State/Province: -
- Country: United States
-
Bobby Lee
- Site Admin
- Posts: 14863
- Joined: 4 Aug 1998 11:00 pm
- Location: Cloverdale, California, USA
- State/Province: -
- Country: United States
-
Donny Hinson
- Posts: 21790
- Joined: 16 Feb 1999 1:01 am
- Location: Glen Burnie, Md. U.S.A.
- State/Province: -
- Country: United States
)