| Author |
Topic: wiring a humbucker directly to jack,no tone or vol pots |
Steve Hudson
From:
weymouth Massachusetts, USA
|
Posted 22 May 2022 2:32 pm |
|
so i recently purchased a homemade console lap steel, with a single single coil wiring directly tot he jack, no vol or tone pots which is fine because obviously i use a volume pedal anyway.
Now unfortunately theres a touch more hum from the single coil than id prefer, so i purchased a single soil spaced humbucker hot rails . my question is since the humbucker has three sets of wires, the silver ( ground?)soldered to a black wire, a single green wire, and a soldered together red and white wire .
If im adding this direct to jack, what am i looking at here wiring wise? and what to do with the leftover wires? |
|
|
|
Bill A. Moore
From:
Silver City, New Mexico, USA
|
Posted 22 May 2022 3:02 pm
|
|
| Solder the black to the sleeve, and the green to the tip. Make sure the other two are insulated. |
|
|
|
Steve Hudson
From:
weymouth Massachusetts, USA
|
Posted 22 May 2022 3:47 pm
|
|
| Bill A. Moore wrote: |
| Solder the black to the sleeve, and the green to the tip. Make sure the other two are insulated. |
going to sound weird but, whats a sleeve or a tip? |
|
|
|
Steve Hudson
From:
weymouth Massachusetts, USA
|
Posted 22 May 2022 3:56 pm
|
|
| Bill A. Moore wrote: |
| Solder the black to the sleeve, and the green to the tip. Make sure the other two are insulated. |
Heres a pic of the jack as it exists now, , which goes where?
 [/img] |
|
|
|
Steve Hudson
From:
weymouth Massachusetts, USA
|
Posted 22 May 2022 7:46 pm
|
|
| Bill A. Moore wrote: |
| Solder the black to the sleeve, and the green to the tip. Make sure the other two are insulated. |
I think i gotcha on this, the inside part is the sleeve( ground) and the outside part if the tip, ( red in the picture,) ill solder the green there then just throw a wire nut and tape off the other wires. right? |
|
|
|
