| Author |
Topic: Red power light for peavey nashville PLEASE CLOSE THREAD |
Robert Rogers
From:
Manchester,TN
|
Posted 14 Nov 2021 5:18 pm |
|
Hey guys my red power light went out on my Peavey Nashville 400 and I was wondering if you guys can tell me what type of light that is and where I can get one.
Last edited by Robert Rogers on 16 Nov 2021 2:45 pm; edited 1 time in total |
|
|
|
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 15 Nov 2021 3:59 am
|
|
Isn't it an LED, not a light? An LED would probably require you to unsolder the bad one and solder the new one in.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, NV400, NV112 . Playing for 54 years and still counting. |
|
|
|
Robert Rogers
From:
Manchester,TN
|
Posted 15 Nov 2021 4:18 am
|
|
| Richard thats what I was thinking but I wasn't sure |
|
|
|
Mike Auman
From:
North Texas, USA
|
Posted 15 Nov 2021 7:09 am
|
|
Robert, it's an LED, you'll need to remove the head from the cabinet to get access to it and solder in a new one. Any amp repair shop should be able to do it for you, it doesn't take a Peavey expert.
_________________
Long-time guitar player, now wrestling with lap steel. |
|
|
|
Bill A. Moore
From:
Silver City, New Mexico, USA
|
Posted 15 Nov 2021 8:27 am
|
|
| Be careful not to lose the snap in bezel! |
|
|
|
Robert Rogers
From:
Manchester,TN
|
Posted 15 Nov 2021 9:48 am
|
|
| Thanks guys.If I can find one of these I'll probably replace it myself. I've always did all the repair work on my nashville 400 myself.so far I've replaced all the pots myself so replacing the led light will be a breeze. |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 15 Nov 2021 11:11 am
|
|
| Robert Rogers wrote: |
| Thanks guys.If I can find one of these I'll probably replace it myself. I've always did all the repair work on my nashville 400 myself.so far I've replaced all the pots myself so replacing the led light will be a breeze. |
Great... be aware that LED's are polarized... there's a flat spot on one side near the cathode I think. Just replace same-same.
Also... LED's don't go bad often... so check the resistor that connects to the LED before you swap it.
_________________
New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329 |
|
|
|
Robert Rogers
From:
Manchester,TN
|
Posted 16 Nov 2021 2:44 pm
|
|
| Thanks guys I found my LED light on eBay. |
|
|
|
