Author |
Topic: Emmons LeGrande Neck With Fretboard (SOLD) |
Lynn Stafford
From: Ridgefield, WA USA
|
Posted 22 Jan 2020 3:20 pm
|
|
I bought this neck from a Forum member a few years ago for a project but didn't end up using it after all. As far as I know, it fits any LeGrande and uses eight 8-32 x 3/4" long flat head screws for mounting.
It would even fit a push-pull if the "prongs" were shortened about 3/8" or so. Note: A push-pull neck is mounted with 6-32 screws, so the holes in the cabinet would need to be enlarged slightly in order to use 8-32 screws to mount this neck.
$165.00 shipped to your door in the lower 48 states, otherwise the shipping cost will be adjusted accordingly.
I can accept PayPal, USPS money order or a personal check, if you're not in a hurry. _________________ Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
----------------------------------
Last edited by Lynn Stafford on 24 Jan 2020 10:50 am; edited 1 time in total |
|
|
|
Bob Cox
From: Buckeye State
|
Posted 23 Jan 2020 7:47 am emmonss neck with frettboard
|
|
Hi Lynn, I will take the neck . Send me Pay pal address. Thanks hope all is good. You going to Dallas this year? Bobby Cox |
|
|
|
Lynn Stafford
From: Ridgefield, WA USA
|
Posted 23 Jan 2020 9:08 am LeGrande Neck
|
|
Hi Bob,
Okay, please consider it yours. I just sent you an email to confirm things. I'll be going to Dallas, so I could bring the neck with me and save you the shipping cost. _________________ Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|