Roland Cube 80

James Taylor · From: United Kingdom

Hi,
I wonder if anyone can help with this situation? I have a Roland Cube 80 amp and it has been working fine. However, for some unknown reason the tone has changed and I have tried altering the controls without success; in fact it sounds toneless to me. Has anyone any ideas what the answer would be???
James Taylor

Stephen Cowell · From: Round Rock, Texas, USA

James, if you could post a clear picture of the controls I'd like to have a look at the settings.
_________________
New FB Page: Lap Steel Licks And Stuff: https://www.facebook.com/groups/195394851800329

Dick Wood · From: Springtown Texas, USA

Try changing cables. I had an issue once where I wasn't getting any volume. I tried another cable and that cured it.
_________________
Cops aren't paid much so I steel at night.

Peter Harris · From: South Australia, Australia

This was discussed (and fixed) on another thread...

https://bb.steelguitarforum.com/viewtopic.php?t=347973&start=25

HTH
Peter
_________________
If my wife is reading this, I don't have much stuff....really!

James Taylor · From: United Kingdom

Hi Stephen,
Thank you, I fixed it by holding down the control switches with the on switch on off position and then with both switches on hold I switched on the power and that has reset it excellently.

This advice I got on another post on this form.

Thank you all on this particular post BLESS YOU ALL

JAMES

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: