| Author |
Topic: Question for Zumsteel owners |
Jim Hollingsworth
From:
Way out West
|
Posted 5 Jan 2019 7:45 pm |
|
I see that Bruce used to make his two tone formica guitars with what looked like chrome stripping between the mica colors instead of the typical pearl/abalone. If you own one like that - is it really a chrome strip?
Just curious.....
Jim |
|
|
|
David Graves
From:
Indiana, USA
|
Posted 5 Jan 2019 10:01 pm
|
|
Jim, I have two Zum D-10s. I think it is different depending on the guitar. My Hybrid has the chrome strip in question and it is an approximately 1/8†chrome tape similar the pin striping tape that would be used on an automobile. My other Zum has the abolone/ pearl stripe but it is an inlay. I hope this helps.
_________________
St. Blues 1984 "Holy Grail"
Take the time to introduce someone young to music... and play a few songs with someone old. |
|
|
|
Paddy Long
From:
Christchurch, New Zealand
|
Posted 6 Jan 2019 5:15 pm
|
|
Both my Hybrids have the Pearl inlays !
_________________
14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases. |
|
|
|
Per Berner
From:
Skövde, Sweden
|
Posted 7 Jan 2019 3:26 am
|
|
| Well, on my Hybrid that mother of pearl looks very much like the famous "mother of toilet seat". 99% sure it is fake plastic pearl. Have never seen one with a chrome dividing strip. |
|
|
|
Danny Letz
From:
Old Glory,Texas, USA 79540
|
Posted 7 Jan 2019 5:41 am
|
|
| When I had my Red, White & Blue lightning bolt built, Bruce said that his joints between colors were very tight & it may not need anything there. When he got it done he said it didn’t look right so he put on the chrome pinstripe. I was worried about it at first but it looks very good & I haven’t had a problem with it. I think I could have gotten the mop at extra cost but I’m happy with what I have. Seems that if you had a problem, it would be easily replaced with a steady hand. |
|
|
|
Richard Lester
From:
Constable, New York, USA
|
Posted 8 Jan 2019 7:50 am Zum stripping
|
|
Hi Jim,
My Zum has the stipping and it looks like chrome to me. You can see for yourself, check out my tune on youtbe: "Running Fast" by Richard Lester
_________________
Zum D-10, GFI S10 keyless ultra, 2020 Flight Ready SD-10 Rittenberry, Quilter Steelaire, Telonics vol. pedal |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 9 Jan 2019 2:11 pm
|
|
Jim, FWIW I sent this picture and asked Bruce about acquiring this trim. You can see what he replied there on the right side. Just automotive trim tape.
I used some adhesive back 1/8" stuff from Autozoo. |
|
|
|
