Author |
Topic: Emmons pull rod thread size CLOSE IT UP |
David Decker
From: Canton, Ohio, USA
|
Posted 3 Jan 2019 2:42 pm
|
|
Who knows the die thread size for an emmons pull rod?
from bell crank to the changer. Need to shorten a longer rod.
Last edited by David Decker on 4 Jan 2019 7:43 am; edited 1 time in total |
|
|
|
Lynn Stafford
From: Ridgefield, WA USA
|
Posted 3 Jan 2019 7:32 pm Re: Emmons pull rod thread size
|
|
David Decker wrote: |
Who knows the die thread size for an emmons pull rod?
from bell crank to the changer. Need to shorten a longer rod. |
David,
You'll need a 5-40 die to rethread your pull rod. _________________ Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
Bobby D. Jones
From: West Virginia, USA
|
Posted 3 Jan 2019 9:13 pm Emmmons pull rod thread size
|
|
5-40 is the standard for a 7/64 rod like Emmons use. |
|
|
|
David Decker
From: Canton, Ohio, USA
|
Posted 4 Jan 2019 3:36 am
|
|
It is for a Legrande II, the rod is .109 |
|
|
|
Ian Rae
From: Redditch, England
|
Posted 4 Jan 2019 7:11 am
|
|
0.109 is 7/64 _________________ Make sleeping dogs tell the truth!
Homebuilt keyless U12 7x5, Excel keyless U12 8x8, Williams keyless U12 7x8, Telonics rack and 15" cabs |
|
|
|