| Author |
Topic: Sierra Artist knee levers and hardware |
Eric Watts
From:
Indiana, USA
|
Posted 1 Dec 2018 4:30 pm |
|
I need the complete right side knee levers set up for a Sierra Artist. It came 3 x 2 set up and I would like to add the other two. Let me know what you might have.
Thanks!!!
Last edited by Eric Watts on 2 Dec 2018 9:30 am; edited 1 time in total |
|
|
|
Michael Yahl
From:
Troy, Texas!
|
Posted 2 Dec 2018 8:02 am
|
|
Check with Jim Palenscar at Steel Guitars of North County. He's also here on the forum. He has all of the old Sierra stock.
_________________
"Don't fergit to kiss yer horse!"
'72 Sho-Bud Professional D10, (in pieces .....), '78 MSA Classic XL D10, '69 Emmons PP, Fender 2000
Peavey Session 500 BW, Crate Digital Modeling Amp
PSG PARTS
http://www.psgparts.com/ |
|
|
|
Eric Watts
From:
Indiana, USA
|
Posted 13 Dec 2018 7:24 pm sierra artist parts
|
|
| Jim has new kit complete for 300$ plus shipping. I know that would be best. I just was hoping for a used or partial set for less money.. Anyone else got some artist knee levers?? |
|
|
|
Eric Watts
From:
Indiana, USA
|
Posted 12 Jan 2019 7:45 am
|
|
| still looking for knees. Anyone ever see a vertical on an Artist??? |
|
|
|
Ron Pruter
From:
Arizona, USA
|
Posted 27 Jan 2021 5:17 pm
|
|
Eric, My Artist came with the cross-shaft for a vertical already installed. I think yours does (if you got it from Marty.) This made taking a piece of alum. angle iron, from Home Depot, cutting a vee out of the side and bending it, then JB weld the notch joint. I bought three pullers, and two rods and installed some kind of adjustable stop. Probably an old Shobud part I had. It worked flawlessly. One word of advice. Call PalenscarðŸ€ðŸðŸ˜®
_________________
Emmons SKH Le Grande, '73 Fender P/J bass, Tick tack bass, Regal high strung, USA Nashville 112. |
|
|
|
