| Author |
Topic: Stairwell Reverb |
Lee Baucum
From:
McAllen, Texas (Extreme South) The Final Frontier
|
|
|
|
Paul Sutherland
From:
Placerville, California
|
Posted 10 Sep 2018 9:48 pm |
|
That sure sounds like the old recordings made by Emmons in the 60s. I would have never guessed it was an all-pull Fessie.
_________________
It don't mean a thing if it ain't got that swing. |
|
|
|
mtulbert
From:
Plano, Texas 75023
|
Posted 11 Sep 2018 2:15 am
|
|
That elevator shaft was also used in Simon and Garfunkel's the boxer. The great break played by Curley Chalker was also recorded in that fashion.
Great sounding reverb.
regards,
_________________
Mark T
Rittenberry Laquer D10, Rittenberry Prestige SD10, Revelation Preamp,Revelation Octal Preamp,Lexicon PCM 92 Reverb, Furlong Cabinet |
|
|
|
Pete Burak
From:
Portland, OR USA
|
Posted 11 Sep 2018 4:28 am
|
|
The vid makes special mention of EQ'ing your Reverb signal.
To EQ Reverb on Fender Twin Reverb and similar two-channel amp, plug your instrument into channel-1, then run a cable from the other channel-1 input to the first channel-2 input.
Turn the Reverb knob up to 10.
Now control the volume of the reverb with the channel-2 volume knob, and EQ it with the channel-2 tone knobs.
You can add a 100%-wet deley between the channel-1 and channel-2 to add a pre-deley to the reveb (allows a little time between the picked note and the beginning of the reverb sound).
Last edited by Pete Burak on 12 Sep 2018 4:15 am; edited 1 time in total |
|
|
|
Bryan Daste
From:
Portland, Oregon, USA
|
|
|
|
forrest klott
From:
Grand Rapids Mi USA
|
Posted 12 Sep 2018 8:36 am
|
|
Lee,
Thank you for posting this! I’d run across that video a couple years back and then have never been able to find it again.
I wonder if there’s a reverb pedal or rack fx unit out there that would let you get close to this sound? If anyone has any suggestions I’d love to hear them.
Skeeter |
|
|
|
