| Author |
Topic: Vibrosonic Reverb |
Ken Pippus
From:
Langford, BC, Canada
|
Posted 13 Jun 2018 2:23 pm |
|
Just to confirm Erv’s point on heartfelt convictions, I just looked at my orange frame JBL, which is quite clearly marked 8 ohms. Someone with a little less grey matter loss should have bet me on that one, as I was very convinced. Mea culpa.
No indication of impedance preference on the amp. |
|
|
|
Pete Burak
From:
Portland, OR USA
|
Posted 16 Jun 2018 9:01 am
|
|
OK here is the back of my Vibrosonic.
As you can see I have had one of the Speaker outputs converted to a Pre-Amp Tap (Line-Out). Sometimes I run it to a McIntosh 250 Solid State Amp, for a different Power Amp and Speaker Cab tonal variation.
Here is the Twin Reverb. It does not have a Pre-Amp Tap, but it does have: Reverb on both Channels, Master Volume removed from circuit, On/off knob to remove Tremelo circuit, and also Channel-1 has a Tone Stack Mod for Pedal Steel (ala Ken Fox as I recall). It has the original blue-label Rola 12" speakers that sound really good so I haven't replaced them.
 |
|
|
|
Ken Pippus
From:
Langford, BC, Canada
|
Posted 1 Jul 2018 7:42 pm
|
|
 |
|
|
|
Ken Pippus
From:
Langford, BC, Canada
|
Posted 1 Jul 2018 7:42 pm
|
|
 |
|
|
|
Pete Burak
From:
Portland, OR USA
|
Posted 1 Jul 2018 7:48 pm
|
|
| Nice job with the white out Ken. |
|
|
|
Ken Pippus
From:
Langford, BC, Canada
|
Posted 1 Jul 2018 8:00 pm
|
|
| Wouldn't that be blackout? Wait, that might be something different! |
|
|
|
