Author |
Topic: Session 400 - 1977 - with new caps/resistors & BW spkr- $350 |
Joe Alterio
From: Irvington, Indiana
|
Posted 22 Jun 2016 9:32 am
|
|
Hi all,
I have a 1977 Session 400 available for sale that I recently updated/upgraded the caps and resistors for per Brad's and Ken's suggestions (pre-amp section). Everything works perfect except the reverb is not responding.
I put in a new BW speaker and it sounds wonderful! I just like the Fender tone too much and need some new pedals, so I'd like to find this one a home where it will get some use.
I will be at the Indy Steel Show/Joe Wright concert this Sunday and can bring it with!
Thanks,
Joe
Last edited by Joe Alterio on 22 Jun 2016 11:24 am; edited 1 time in total |
|
|
|
Joe Alterio
From: Irvington, Indiana
|
Posted 22 Jun 2016 11:23 am
|
|
Forgot to add...I'd like to get $350 for it.
Thanks!
Joe |
|
|
|
Paul Norman
From: Washington, North Carolina, USA
|
Posted 22 Jun 2016 3:59 pm
|
|
Unplug the cord that runs from the amp to the reverb tank. If you have some spray electronic cleaner into the plug. If not turn the plug around if it will fit that way. Sometimes that is all there is to it. |
|
|
|
Joe Alterio
From: Irvington, Indiana
|
Posted 24 Jun 2016 5:42 am
|
|
Thanks, Paul...I gave it a shot, but no dice. As it was working before I replaced the caps and resistors, I suspect I may have knocked something loose on the circuit board...but that takes me just a bit out of my comfort zone as something I could remedy. |
|
|
|