Search found 1095 matches

https://hipshotproducts.com/products/roller-nut

https://www.tubesandmore.com/products/reverb-tank-mod-9ab2a1b-medium-decay-3-spring

The only reason I could see for going with a N400 is because you need more power. If the Fender is could enough for you then just replace the tubes. And don't just replace the tubes because you thin ...

I have a B50 that's new in the box. I will do a straight across trade if you are still interested.

That '61 Strat looks just like my early '62 but my '62 has all gold hardware. If the pickup switch hasn't been replaced with a 5 position switch, the toggle could be to switch in the middle pickup fo ...

If you can't open the amp, the tube chart should be an an approximate indicator. If it was a CBS Fender it should have something different on the rear panel other than Fender, Fullerton.

It looks like the top bobbin piece would need to be replaced but the pickup should be able to be rewound.

Speaking of Jesse Ed Davis, I was impressed with his playing when I heard him playing with Taj Mahal at a Cream concert at Earl Warren Showgrounds, Santa Barbara, back in 1968. Didn't have a clue who ...

Urban myth . The real question for Fender about about adding a MV is it actually didn't do anything other than adjust the output volume,

I wish that was true, but they put that pesky little ca ...

I am in California and do rewinds.

I am pretty sure that Amplified Parts is the same as Antique Electronics, so you can buy them from either website.

I believe you know Bill House. I know he has at least one. Give him a call.

Yep, that's the only stuff to use for those skinny traces. I had a board where the power rail shorted to ground on the board, burning a big hole in the board that went into an IC's pads. Had to cut ...

I use kynar wire for those little traces. That's what we used back at Northrop Electronics Division for open traces on multi-layer boards.

For that much damage, 4 hours sounds about right. Justification of tech time depends on whether used ones are available.

Looking at the pictures, it is repairable but will cost a lot of bench time to jumper and remove all the bad traces. In my experience it's better to remove the old trace when it's damaged that bad.

Yes, the Bright switch bleeds highs across the high and wiper of the Volume control, so higher the Volume lower the amount of bleed. On a SF Twin with a Master Volume, there is a bright circuit acros ...

If I remember my transformer theory from college electronics, I believe it could be two times the level for the higher impedance output.

The Line 6 SonicPort uses the "Mobile POD" app on my iPhone and iPad. Haven't tried it with any other apps.

Herco makes a thumb pick that is shaped just like a regular guitar pick but with a loop over for your thumb. They don't dig in as bad as a regular thumb pick so it might be a good option, especially ...

I've used the Line 6 Sonic Port with the free amp/fx simulator software. I even used it for recording demo tapes once to get better isolation and control of my sound. It worked fine for guitar but d ...

From my research, GPA has the original Altec tooling that they use to make the recone kits. They have really good reviews but their kits cost about $120 compared to the $65 for the generic kits.

I even put an EVM 12L in my Blues Deluxe and it still just wasn't enough power. The only way to get enough out of this amp is to replace the power and output transformers with those from a DeVille. ...

I'm still wondering whether lefthandedness is on a spectrum which goes through right-handed and ambidextrous to slightly and completely left.

I watch a lot of football (soccer) and I notice that pl ...

Author	Message
Topic: Roller nut for behind the bar bends
Michael Brebes Replies: 5 Views: 367	Forum Section: Steel Without Pedals Posted: 18 Jul 2020 8:12 am Subject: Roller nut for behind the bar bends
Michael Brebes Replies: 5 Views: 367	https://hipshotproducts.com/products/roller-nut
Topic: Mod Reverb Tank For Blackface Twin
Michael Brebes Replies: 2 Views: 223	Forum Section: Electronics Posted: 8 Jul 2020 5:45 am Subject: Mod Reverb Tank For Blackface Twin
Michael Brebes Replies: 2 Views: 223	https://www.tubesandmore.com/products/reverb-tank-mod-9ab2a1b-medium-decay-3-spring
Topic: Fender hot rod vs. Nashville 400
Michael Brebes Replies: 16 Views: 677	Forum Section: Electronics Posted: 7 Jul 2020 5:35 am Subject: Fender hot rod vs. Nashville 400
Michael Brebes Replies: 16 Views: 677	The only reason I could see for going with a N400 is because you need more power. If the Fender is could enough for you then just replace the tubes. And don't just replace the tubes because you thin ...
Topic: F logo B5 Bigsby Tele Vibrato Sell or Trade for B50 Import
Michael Brebes Replies: 3 Views: 728	Forum Section: For Sale: Amps and Accessories Posted: 29 Jun 2020 9:46 am Subject: F logo B5 Bigsby Tele Vibrato Sell or Trade for B50 Import
Michael Brebes Replies: 3 Views: 728	I have a B50 that's new in the box. I will do a straight across trade if you are still interested.
Topic: Dating bassman fender amp
Michael Brebes Replies: 17 Views: 799	Forum Section: Electronics Posted: 27 Jun 2020 5:49 am Subject: Dating bassman fender amp
Michael Brebes Replies: 17 Views: 799	That '61 Strat looks just like my early '62 but my '62 has all gold hardware. If the pickup switch hasn't been replaced with a 5 position switch, the toggle could be to switch in the middle pickup fo ...
Topic: Dating bassman fender amp
Michael Brebes Replies: 17 Views: 799	Forum Section: Electronics Posted: 26 Jun 2020 5:58 am Subject: Dating bassman fender amp
Michael Brebes Replies: 17 Views: 799	If you can't open the amp, the tube chart should be an an approximate indicator. If it was a CBS Fender it should have something different on the rear panel other than Fender, Fullerton.
Topic: NGD Vintage
Michael Brebes Replies: 12 Views: 916	Forum Section: Steel Without Pedals Posted: 20 Jun 2020 7:15 am Subject: NGD Vintage
Michael Brebes Replies: 12 Views: 916	It looks like the top bobbin piece would need to be replaced but the pickup should be able to be rewound.
Topic: David Lindley on Doctor My Eyes live.
Michael Brebes Replies: 11 Views: 1229	Forum Section: Steel Without Pedals Posted: 20 Jun 2020 7:06 am Subject: David Lindley on Doctor My Eyes live.
Michael Brebes Replies: 11 Views: 1229	Speaking of Jesse Ed Davis, I was impressed with his playing when I heard him playing with Taj Mahal at a Cream concert at Earl Warren Showgrounds, Santa Barbara, back in 1968. Didn't have a clue who ...
Topic: Old MV Fender amp question
Michael Brebes Replies: 11 Views: 708	Forum Section: Electronics Posted: 16 Jun 2020 6:41 am Subject: Old MV Fender amp question
Michael Brebes Replies: 11 Views: 708	Urban myth . The real question for Fender about about adding a MV is it actually didn't do anything other than adjust the output volume, I wish that was true, but they put that pesky little ca ...
Topic: 1972 Fender Vibrosonic Reverb w/split cab, fx both channels
Michael Brebes Replies: 38 Views: 8429	Forum Section: For Sale: Amps and Accessories Posted: 15 Jun 2020 2:51 pm Subject: 1972 Fender Vibrosonic Reverb w/split cab, fx both channels
Michael Brebes Replies: 38 Views: 8429	ttt
Topic: winding pickups?
Michael Brebes Replies: 11 Views: 816	Forum Section: Electronics Posted: 7 Jun 2020 9:32 am Subject: winding pickups?
Michael Brebes Replies: 11 Views: 816	I am in California and do rewinds.
Topic: Mod Reverb
Michael Brebes Replies: 16 Views: 2277	Forum Section: Electronics Posted: 26 Apr 2020 9:11 am Subject: Mod Reverb
Michael Brebes Replies: 16 Views: 2277	I am pretty sure that Amplified Parts is the same as Antique Electronics, so you can buy them from either website.
Topic: JBL speakers
Michael Brebes Replies: 2 Views: 1071	Forum Section: Electronics Posted: 18 Apr 2020 2:48 pm Subject: JBL speakers
Michael Brebes Replies: 2 Views: 1071	I believe you know Bill House. I know he has at least one. Give him a call.
Topic: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Forum Section: Electronics Posted: 12 Apr 2020 11:52 am Subject: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Yep, that's the only stuff to use for those skinny traces. I had a board where the power rail shorted to ground on the board, burning a big hole in the board that went into an IC's pads. Had to cut ...
Topic: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Forum Section: Electronics Posted: 11 Apr 2020 9:17 am Subject: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	I use kynar wire for those little traces. That's what we used back at Northrop Electronics Division for open traces on multi-layer boards.
Topic: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Forum Section: Electronics Posted: 10 Apr 2020 8:20 am Subject: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	For that much damage, 4 hours sounds about right. Justification of tech time depends on whether used ones are available.
Topic: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Forum Section: Electronics Posted: 9 Apr 2020 8:31 am Subject: Ugly Profex battery damage
Michael Brebes Replies: 10 Views: 1213	Looking at the pictures, it is repairable but will cost a lot of bench time to jumper and remove all the bad traces. In my experience it's better to remove the old trace when it's damaged that bad.
Topic: Amp Questions
Michael Brebes Replies: 25 Views: 1761	Forum Section: Electronics Posted: 20 Mar 2020 6:48 am Subject: Amp Questions
Michael Brebes Replies: 25 Views: 1761	Yes, the Bright switch bleeds highs across the high and wiper of the Volume control, so higher the Volume lower the amount of bleed. On a SF Twin with a Master Volume, there is a bright circuit acros ...
Topic: Fender Vibrosonic reverb tank
Michael Brebes Replies: 22 Views: 2248	Forum Section: Electronics Posted: 19 Mar 2020 6:21 am Subject: Fender Vibrosonic reverb tank
Michael Brebes Replies: 22 Views: 2248	If I remember my transformer theory from college electronics, I believe it could be two times the level for the higher impedance output.
Topic: iPhone-based silent practicing and effects devices?
Michael Brebes Replies: 20 Views: 1530	Forum Section: Electronics Posted: 6 Mar 2020 6:17 am Subject: iPhone-based silent practicing and effects devices?
Michael Brebes Replies: 20 Views: 1530	The Line 6 SonicPort uses the "Mobile POD" app on my iPhone and iPad. Haven't tried it with any other apps.
Topic: Adaptive Techniques for Disabled Veteran to Play the Blues
Michael Brebes Replies: 10 Views: 1000	Forum Section: Steel Without Pedals Posted: 3 Mar 2020 6:56 am Subject: Adaptive Techniques for Disabled Veteran to Play the Blues
Michael Brebes Replies: 10 Views: 1000	Herco makes a thumb pick that is shaped just like a regular guitar pick but with a loop over for your thumb. They don't dig in as bad as a regular thumb pick so it might be a good option, especially ...
Topic: iPhone-based silent practicing and effects devices?
Michael Brebes Replies: 20 Views: 1530	Forum Section: Electronics Posted: 3 Mar 2020 6:50 am Subject: iPhone-based silent practicing and effects devices?
Michael Brebes Replies: 20 Views: 1530	I've used the Line 6 Sonic Port with the free amp/fx simulator software. I even used it for recording demo tapes once to get better isolation and control of my sound. It worked fine for guitar but d ...
Topic: Who repairs Altec speakers?
Michael Brebes Replies: 10 Views: 758	Forum Section: Electronics Posted: 2 Mar 2020 7:29 am Subject: Who repairs Altec speakers?
Michael Brebes Replies: 10 Views: 758	From my research, GPA has the original Altec tooling that they use to make the recone kits. They have really good reviews but their kits cost about $120 compared to the $65 for the generic kits.
Topic: Fender Hot Rod Deluxe
Michael Brebes Replies: 29 Views: 2286	Forum Section: Electronics Posted: 1 Mar 2020 7:58 am Subject: Fender Hot Rod Deluxe
Michael Brebes Replies: 29 Views: 2286	I even put an EVM 12L in my Blues Deluxe and it still just wasn't enough power. The only way to get enough out of this amp is to replace the power and output transformers with those from a DeVille. ...
Topic: Who makes leftie steels?
Michael Brebes Replies: 26 Views: 1792	Forum Section: Pedal Steel Posted: 29 Feb 2020 7:21 am Subject: Who makes leftie steels?
Michael Brebes Replies: 26 Views: 1792	I'm still wondering whether lefthandedness is on a spectrum which goes through right-handed and ambidextrous to slightly and completely left. I watch a lot of football (soccer) and I notice that pl ...