| Author |
Topic: Tying up a goodrich pot |
Burton Lee
From:
Denton, Texas, USA
|
Posted 25 May 2004 10:38 am |
|
I took apart my L120 to fix a noise problem (which worked, I think-- grounding problem, not dirty pot) but I undid the yellow string to do it. Duh!
I read Jeff Newman's article on Carter's website but I'm not following his brief description of how to string it.
If anybody feels capable of describing the process easily, or knows a good description online, please help me before I make a little yellow hangman's noose.
Thanks in advance,
Burton Lee
MCI D-10, Session 500
Denton, TX
PS. I'm able to wind it so that the post travels properly provided I'm pulling the slack end of the string taut. What I can't figure out is how to tie it so that when the pedal is released (and I'm not pulling the end) it winds instead of just going slack.
[This message was edited by Burton Lee on 25 May 2004 at 12:06 PM.] |
|
|
|
George Kimery
From:
Limestone, TN, USA
|
Posted 25 May 2004 1:19 pm
|
|
| Check your e-mail. |
|
|
|
Bill Moore
From:
Manchester, Michigan
|
|
|
|
Burton Lee
From:
Denton, Texas, USA
|
Posted 25 May 2004 3:06 pm
|
|
Thanks! That Scotty's diagram was exactly what I needed!
(The pedal went scratchy again... new pot time)
|
|
|
|
Burton Lee
From:
Denton, Texas, USA
|
Posted 26 May 2004 8:05 am
|
|
Yeah, the pedal is right back to full-on static mode.
What do you guys think? When I took it apart, the sound cleaned up immediately. I could rotate the shaft on the pot (with instrument connected) and the sound was 100% clean. I know one of the leads to the pot is microphonic, and some of the sound was the wire touching the floor of the pedal.
If the pot operates cleanly while partially disassembled, does it mean I'm barking up the wrong tree with a new pot? Is my problem in the grounding of the pedal?
Thanks in advance for your insight!
Burton Lee
MCI D-10, Session 500, Noisy Goodrich Pedal
Denton, TX
|
|
|
|
John Bechtel
From:
Nashville, Tennessee, R.I.P.
|
Posted 26 May 2004 11:44 pm
|
|
Burton;
Make sure the collar is not on the shaft so far that the edge of the collar rubs the mounting-threads of the pot itself when turning ON/OFF.
------------------
“Big John” Bechtel
Franklin PSG D–10 (9 & 
Fender ’49–’50 T–8 Custom
Fender ’65 Reissue Twin-Reverb Custom™ 15”
click here
click here
|
|
|
|
