| Author |
Topic: Session 400 Hum |
Rick Lane
From:
Shawano, Wisconsin, USA
|
Posted 14 May 2004 7:25 pm |
|
Hi Everybody,
Would anybody out there know how to cure a
hum in my session 400 limited wedge amp.
I unpluged all my cords,thought maybe a bad
cord but that did not help.Thought maybe a
bad house ground,but I have another amp plugged into the same outlet and that one
dosen't hum. If anyone has any ideals
please let me know.
THANKS,
RICK |
|
|
|
Dennis Detweiler
From:
Solon, Iowa, US
|
Posted 15 May 2004 3:04 pm
|
|
Possibly filter caps?
DD |
|
|
|
Brad Sarno
From:
St. Louis, MO USA
|
Posted 15 May 2004 5:20 pm
|
|
Does it still hum with the reverb off?
Brad Sarno
|
|
|
|
Rick Lane
From:
Shawano, Wisconsin, USA
|
Posted 15 May 2004 7:27 pm
|
|
Hi Brad,
When I press the reverb switch off on the
pedal it doesn't hum, but if I use the
volume pedal for my steel I can still
hear a little hum.
THANKS!
RICK |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 18 May 2004 8:09 am
|
|
Rick,
Check the ground wires on your reverb wiring connections. This could be the problem since you can turn the reverb off and the hum ceases.
If you experience a hum when using your volume pedal, simply eliminate your volume pedal and if the hum continues, take your amp to an authorized service center. Here is a link to our service locator from our website;
http://www.peavey.com/support/dealerlocator/
Mike Brown
Peavey Electronics Corporation |
|
|
|
Rick Lane
From:
Shawano, Wisconsin, USA
|
Posted 22 May 2004 1:32 pm
|
|
Thanks everyone for the help. I will try
these suggestions.
THANKS AGAIN
RICK
|
|
|
|
Bob Snelgrove
From:
san jose, ca
|
Posted 22 May 2004 4:18 pm
|
|
Brad
Any cap kits available yet? 
bob |
|
|
|
Bob Snelgrove
From:
san jose, ca
|
Posted 22 May 2004 5:36 pm
|
|
I think he said Reverb "PEDAL" ??
bob |
|
|
|
