| Author |
Topic: PV-260 Power Amp |
William Peters
From:
Effort, Pennsylvania, USA
|
Posted 5 May 2004 12:48 pm |
|
Anyone got one of these? I want to know if you are able to drive it to full power with a guitar preamp like a Peavey tubefex, or a Behringer V-Amp Pro. I cannot drive mine hard enough to active the DDT leds with either of my preamps, and if I crank my preamps any harder, they start to clip. It sounds good if I don't overdrive the preamp, but it doesn't sound 200 watts loud if you know what I mean.
Bill
http://www.wgpeters.com
|
|
|
|
Dyke Corson
From:
Fairmount, IL USA
|
Posted 5 May 2004 8:51 pm
|
|
| I used one of the PV260s for a while, then when we were doing outside high stage volume festivals I switched to a DPC750 for more headroom. The PV260 worked fine for small to medium clubs with a moderate stage volume. Good for a church gig too, no fan noise! |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 6 May 2004 5:11 am
|
|
The nominal input sensitivity level is 1 volt. The Tubefex can easily produce one volt. Check your global output level on the Tubefex.
Mike Brown
Peavey Electronics Corporation |
|
|
|
William Peters
From:
Effort, Pennsylvania, USA
|
Posted 6 May 2004 1:11 pm
|
|
Mike,
I think the trouble is my pedal doesn't reach full output. If if take out the pedal, it shatters my windows and the runs for cover. My global pre gain and post gain are both at 100. I knew the specs said it should work.
Thanks,
Bill
|
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 7 May 2004 6:22 am
|
|
| I'm glad that you uncovered the problem. If I can assist further, please let me know. |
|
|
|
