| Author |
Topic: Question for Mike Brown at Peavy |
Roger A Trahan
From:
New Bedford, Mass. USA
|
Posted 12 Sep 2000 12:40 pm |
|
| I just purchased a new CS 800 S power amp and find that in the stereo mode the A channel overpowers thr B channel completly. I bought this amp thinking I could control each channel seperately but it hasn't worked out that way. Any ideas? |
|
|
|
Derrell Stephens
From:
Shreveport, La. USA
|
Posted 17 Sep 2000 5:43 am
|
|
I'm not Mike, but check to see if the "bridge mode" switch is set the wrong way.
Derrell |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 18 Sep 2000 6:03 am
|
|
Thanks for stepping in for me, Derrell.
I suggest that you swap the input signals to the amplifier to check if the lower signal levels follows the channel. If it does, it's the source that is causing the problem. If it doesn't, I suggest that you have an authorized Peavey service center technician check the amp out for you.
If the amp was in 'bridge' mode, channel B wouldn't work at all.
You may contact me at 1-877-732-8391 toll free here at the factory. |
|
|
|
