| Author |
Topic: restoring old tone bars |
Andrew Frost
From:
Toronto, Ontario
|
Posted 27 Feb 2024 11:19 am |
|
posting here, as builders are likely to have a more practical sense of materials.
I have an old Ernie Ball tone bar that I acquired about 20 years ago and haven't used in ages. The finish has become rather mat-like and makes a grinding friction on the strings.
Nort sure what exact material it is. I applied some 'silvo' polish a couple times and the finish to touch now feels the same as my dunlop bars, which is good, but it still doesn't have that smoothness to it and still grinds somewhat on the strings.
Any way to get this thing polished up to a functional condition? |
|
|
|
Barry Coker
From:
Bagley Alabama, USA
|
Posted 28 Feb 2024 5:02 am
|
|
If the bar is Stainless Steel and it wasn't Chromed it can posable be polished but if it is steel that was chromed over polishing will cause it to rust when the chrome is gone.
Powder coating might be an option.
Barry
_________________
Zum-D-10, Webb 614-E, 65 Pro Reverb, Evans RE200, 69 Gibson Birdland, 89 Telecaster EAD Bad!! |
|
|
|
Richard Sinkler
From:
aka: Rusty Strings -- Missoula, Montana
|
Posted 28 Feb 2024 6:17 am
|
|
And as I stated in your other post, replating a chrome bar would cost way more than buying a new one.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, NV400, NV112 . Playing for 54 years and still counting. |
|
|
|
Andrew Frost
From:
Toronto, Ontario
|
Posted 2 Mar 2024 11:17 am
|
|
Duly noted.
Thank you
A |
|
|
|
