Author |
Topic: ZB Custom |
Danny Caporn
From: Western Australia
|
Posted 23 Apr 2024 3:24 am
|
|
I have a C6 changer that would like to used on a S11 E9 build.
I understand that the C6 is shorter than E9.
Can a ZB forum member advise me of the difference in measurements so I can modify this C6 changer. |
|
|
|
B. Greg Jones
From: Middleport, Ohio USA
|
Posted 23 Apr 2024 3:48 pm
|
|
The changers are the same and can be used on either neck.
Greg |
|
|
|
Danny Caporn
From: Western Australia
|
Posted 27 Apr 2024 1:35 am
|
|
Hi,
This the changer finger I have which appears to be different to to any I've seen on the net or forum. It came out of a D11 so is it factory.
Regards Danny
[/img] |
|
|
|
Eric Dahlhoff
From: Point Arena, California
|
Posted 27 Apr 2024 7:18 am ZB changer
|
|
Wow, I've never seen one quite like that
Usually the tops have removable caps, although I had an early one without caps. But it had pins for the string ends, not a groove like yours.
Also, the threaded end is too short. So yes, that doesn't look like it would fit in a "normal" ZB changer housing.
Here's one
_________________ "To live outside the law you must be honest." (Bob Dylan) |
|
|
|