Author |
Topic: Peavey Session 400 LTD reverb help |
Jerry Roller
From: Van Buren, Arkansas USA
|
Posted 12 Jun 2017 4:20 pm
|
|
Can someone ID which RCA jack is reverb output (or input). This is the LTD and not Limited. I don' know how to hook up the reverb tank and need help.
Thanks,
Jerry _________________ http://www.littleoprey.org/ |
|
|
|
Lane Gray
From: Topeka, KS
|
Posted 12 Jun 2017 6:42 pm
|
|
IIRC, the two leads are of different lengths so that it will only hook up one way as long as the jacks face front. If you've replaced the cables, I dunno. _________________ 2 pedal steels, a lapStrat, and an 8-string Dobro (and 3 ukes)
More amps than guitars, and not many effects |
|
|
|
Doug Earnest
From: Branson, MO USA
|
Posted 12 Jun 2017 7:31 pm
|
|
In the diagram Ken Fox posted recently, if you are looking at the back of the amp and the pan jacks are facing the front of the amp as they should be the input jack is on the left side of the tank. I think Mike Brown also posted on this a few months back. |
|
|
|
Jerry Roller
From: Van Buren, Arkansas USA
|
Posted 12 Jun 2017 9:40 pm
|
|
The tank is labeled. I need to know about the jacks on the chassis. _________________ http://www.littleoprey.org/ |
|
|
|
Jerry Overstreet
From: Louisville Ky
|
Posted 13 Jun 2017 4:12 am
|
|
If you hook it up backwards it will hum...so just reverse the cables. |
|
|
|
Jerry Jones
From: Franklin, Tenn.
|
Posted 13 Jun 2017 4:20 am
|
|
Viewed from rear.... right side of pan connected to input jack closest to rear of amp and mine is also marked with red marker. Don't know if that's factory, though. _________________ Jerry Jones |
|
|
|
Ken Fox
From: Nashville GA USA
|
Posted 13 Jun 2017 5:05 am
|
|
Take the RCA cable loose from the tank. Turn up the reverb on the amp and touch the two lead tips. The one that makes noise goes to the tank output.
The tank will in fact work backward, but will have a bit if hum. In the case of a Fender tube amp it will not work at all backwards. |
|
|
|
Jerry Roller
From: Van Buren, Arkansas USA
|
|
|
|