| Author |
Topic: question about mullen crosshafts |
Mike Archer
From:
church hill tn
|
Posted 23 Mar 2017 10:17 am |
|
on mullen RP D-10 how do to remove the crosshafts
are they spring loaded or what?
I need to move one from the up lever to the 0 pedal position
thanks for any help
_________________
Mullen sd10
Nashville 400 amp
Tele/ fender deluxe |
|
|
|
Wayne Quinn
From:
Cape Breton.NovaScotia
|
Posted 23 Mar 2017 6:39 pm mickey adams
|
|
Mike ,i would give Mickey Adams a hit . he can tell you in a hart beat all about your Mullen. and a great guy to boot .
_________________
D10 Carter, SD10 Mullen .Nashville 400,. peavey 112 Boss DD3., RV5, |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 23 Mar 2017 6:56 pm
|
|
They don't come out. At least they did not on my PRP.
You'd have to cut it. You can buy a 2pc. split shaft and bushings from Mullen. That's what their add-on kits use...or buy some 5/16" hex stock and make one yourself.
They are made with a lap joint and a screw that holds the 2 halves together.
Photo of a half of one I made a few years ago out of stainless steel. Quite a chore to work with. Easier to buy one from Mullen.
 |
|
|
|
Mike Archer
From:
church hill tn
|
Posted 24 Mar 2017 6:25 am mullen
|
|
thanks Jerry what the deal is the guy that had this guitar before me had removed the first crosshaft
for whatever reason and threw all the parts away
except the pedal rod and pedal
so I guess ill get the add on from mullen
thanks for the info
mike
_________________
Mullen sd10
Nashville 400 amp
Tele/ fender deluxe |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 24 Mar 2017 6:32 am
|
|
| As suggested, you might contact Mickey. He may have some used parts or other ideas as well. Good Luck. |
|
|
|
Mike Mantey
From:
Eastern Colorado, USA
|
Posted 24 Mar 2017 7:27 am
|
|
| You can remove them on the RP. Remove all the parts attached and remove the front and back retainer clip and pull the cross rod into the back panel as far as it will go and then the front should be able to pulled up and then just pull the rod out with the bushings. It's a tight fit but should come out. |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 24 Mar 2017 8:57 am
|
|
I defer to Mike, of course. Sorry for the misinformation Mike (Archer).  I forgot the RP doesn't have the center rail like my PRP's.
Last edited by Jerry Overstreet on 24 Mar 2017 9:12 am; edited 1 time in total |
|
|
|
Mike Mantey
From:
Eastern Colorado, USA
|
Posted 24 Mar 2017 9:12 am
|
|
| Jerry you were correct that they did not come out on the PreRp without removing the undercarriage. Just one of the improvements on the RP and G2. |
|
|
|
