The Steel Guitar Forum Store 

Post new topic Anyone seen this before?
Reply to topic
Author Topic:  Anyone seen this before?
Larry Welter


From:
Wisconsin, USA
Post  Posted 6 Feb 2016 10:16 am    
Reply with quote

Found this on ebay on a carter starter,,this was new to me,,,
Shocked Shocked
_________________
a few guitars,(Rickenbacker /610/ 40,s lap steel, 2007 emmons legrande,student Gs emmons,,,nashville 112
....,peavey classic 30 ,Nashville 400,,a few effect pedals,,everything except talent,(everyone wants to go to heaven,but no one wants to die to get there,) "steven jobs"?
View user's profile Send private message Send e-mail

Tim Russell


From:
Pennsylvania, USA
Post  Posted 6 Feb 2016 10:20 am    
Reply with quote

What are they - foot "knee levers?" Hmmm...my mind is thinking of the possibilities... Wink
_________________
Sierra Crown D-10
View user's profile Send private message

Jon Light


From:
Saugerties, NY
Post  Posted 6 Feb 2016 10:37 am    
Reply with quote

Is a flexing, torquing pedal bar an issue with a CS? I don't recall that, the couple of times I've sat at one. That is the only sense I can make of that.
View user's profile Send private message Send e-mail Visit poster's website

Larry Welter


From:
Wisconsin, USA
Post  Posted 6 Feb 2016 10:40 am     ad
Reply with quote

in the ebay ad they called these stablizers,,,my carter tends to move/walk when I play,,but I have home made legs which is a problem,,
_________________
a few guitars,(Rickenbacker /610/ 40,s lap steel, 2007 emmons legrande,student Gs emmons,,,nashville 112
....,peavey classic 30 ,Nashville 400,,a few effect pedals,,everything except talent,(everyone wants to go to heaven,but no one wants to die to get there,) "steven jobs"?
View user's profile Send private message Send e-mail

Jon Light


From:
Saugerties, NY
Post  Posted 6 Feb 2016 10:45 am    
Reply with quote

If the bar were to flex/torque with a heavy pedal foot, the pedals could bottom out on the floor. But I think I'd remember that---a flimsy pedal bar would leave an impression. Bottom line--whoever fabricated those didn't do it for no reason.
View user's profile Send private message Send e-mail Visit poster's website

Michael Maddex


From:
Northern New Mexico, USA
Post  Posted 6 Feb 2016 11:05 am    
Reply with quote

The Pedal Bar on the C-Starter that I had was very flimsy, just a piece of one-by lumber. Along with the Knee Lever Stops, it was one of the weakest points of the guitar. Otherwise, not a bad beginner's instrument.

I must say, those are some mighty fancy homemade Stabilizers.
_________________
"For every expert, there is an equal and opposite expert." -- Arthur C. Clarke
View user's profile Send private message Send e-mail Visit poster's website

J R Rose

 

From:
Keota, Oklahoma, USA
Post  Posted 6 Feb 2016 1:12 pm    
Reply with quote

I am guessing they are to keep the pedal rack from twisting. Or feeling spongy, (soft). I have set behind some that were like that so I think it is a good ideal. J.R. Rose
_________________
NOTHING..Sold it all. J.R. Rose
View user's profile Send private message Send e-mail

Ron Kassof

 

From:
Las Vegas, NV, USA
Post  Posted 7 Feb 2016 9:24 am    
Reply with quote

I agree with Larry. The Carter Starter has a tendency for a lot of lateral movement when the knee levers are used. Also, bending of the levers against the stops, jumping the stops, etc. While the wooden pedal board doesn't seem that sturdy, those "stabilizers" don't look like they'd do much of anything to prevent it from bending or flexing. They seem to function as the equivalent of wider leg bases.
View user's profile Send private message Send e-mail

Bill Terry


From:
Bastrop, TX
Post  Posted 7 Feb 2016 9:30 am    
Reply with quote

Training wheels? Just keep your foot between the rails.. Smile
_________________
Lost Pines Studio
"I'm nuts about bolts"
View user's profile Send private message Send e-mail

Donny Hinson

 

From:
Glen Burnie, Md. U.S.A.
Post  Posted 7 Feb 2016 12:52 pm    
Reply with quote

Quote:
What are they?


In a word, "ridiculous".

Laughing
View user's profile Send private message Send e-mail

Danny Letz

 

From:
Old Glory,Texas, USA 79540
Post  Posted 7 Feb 2016 4:21 pm    
Reply with quote

It could be a gyroscope for when you get to drunk to play. Or maybe a governor if you get to playing to fast. Maybe it pecks you on the foot if you screw up?
View user's profile Send private message Send e-mail

Craig Baker


From:
Eatonton, Georgia, USA - R.I.P.
Post  Posted 7 Feb 2016 9:01 pm    
Reply with quote

Just a guess. . . but if they were moved inward closer to each other, they might possibly keep your foot from straying too far to the left or right until you get the feel of the guitar. Somebody went to a lot of trouble. Who knows why?

Craig
_________________
"Make America Great Again". . . The Only Country With Dream After Its Name.
View user's profile Send private message Send e-mail

Kenny Foy

 

From:
Lynnville, KY, USA
Post  Posted 9 Feb 2016 5:06 am    
Reply with quote

No rod connection so has to be for a type of stabilization situation.
View user's profile Send private message Send e-mail

Ian Rae


From:
Redditch, England
Post  Posted 9 Feb 2016 7:03 am    
Reply with quote

My very first thought was that they might be nothing to do with playing at all, but might fold in to retain the pedals when packing and unpacking, to stop them flapping about. They certainly don't look as though they'd offer any support to the pedal bar while playing.
_________________
Make sleeping dogs tell the truth!
Homebuilt keyless U12 7x5, Excel keyless U12 8x8, Williams keyless U12 7x8, Telonics rack and 15" cabs
View user's profile Send private message Send e-mail Visit poster's website


All times are GMT - 8 Hours
Jump to:  

Our Online Catalog
Strings, CDs, instruction,
steel guitars & accessories

www.SteelGuitarShopper.com

Please review our Forum Rules and Policies

Steel Guitar Forum LLC
PO Box 237
Mount Horeb, WI 53572 USA


Click Here to Send a Donation

Email admin@steelguitarforum.com for technical support.


BIAB Styles
Ray Price Shuffles for
Band-in-a-Box

by Jim Baron
HTTP