| Author |
Topic: problem with m-box/pro tools rig...help |
Chris Erbacher
From:
Sausalito, California, USA
|
Posted 2 Jan 2007 3:28 pm |
|
| hey guys, i just got my pro tools rig up and going on my mac...it is an older version of pro tools 5.2LE? works with os 9.2. anyway, i got it working and then while i was recording a track, i noticed this clicking noise where the levels spike at regular intervals, causing a clicking noise that gets recorded onto the track. it happens regardless of whether or not the knob for gain is turned up or not and is really annoying. i'm wondering if anyone out there has had this problem, or has any ideas of where to go from here? i hope it isn't the pre (m-box). thanks in advance for help, peace |
|
|
|
Steve Stallings
From:
Houston/Cypress, Texas
|
Posted 2 Jan 2007 3:53 pm
|
|
CPU spikes are generally caused by the latency settings being to low. Try adjusting your latency settings to a tad higher setting and see what happens.
_________________
Steve Stallings
Emmons Legrande II 8X5 |
|
|
|
Chris Erbacher
From:
Sausalito, California, USA
|
Posted 2 Jan 2007 4:00 pm
|
|
| thanks, i am not sure what a latency setting is though (to be honest)...i am new to this... |
|
|
|
Chris Tarrow
From:
Maplewood, NJ
|
Posted 4 Jan 2007 2:12 pm
|
|
Sounds like it might be a clocking error? I'm not in front of PT so I'm not sure, but I think under "Hardware Setup" make sure your Clock Source is set to INTERNAL. There's a lot of helpful folks on the Digidesign BBS:
http://duc.digidesign.com
Hope that helps. |
|
|
|
Al Terhune
From:
Newcastle, WA
|
Posted 5 Jan 2007 8:57 am
|
|
Chris,
I've had several snags and always (except once) found help on Digidesign's PT forum:
http://duc.digidesign.com/
_________________
Al
My equipment:
One heck of a Wife
The ghost of a red Doberman
Several pairs of reading glasses strewn about |
|
|
|
