The Steel Guitar Forum Store 

Post new topic huming
Reply to topic
Author Topic:  huming
dana Murphy

 

From:
clarksburg wv usa
Post  Posted 21 Jan 2000 3:29 pm    
Reply with quote


I am useing a evans preamp & a lexicon mpx 100. It is in a 4 space rack case I can,t seem to find a place to put the wall wart with out eny hum is there tricks i could use? How do you have yours setuo thanks dana

View user's profile Send private message Send e-mail

Jack Stoner


From:
Kansas City, MO
Post  Posted 21 Jan 2000 3:55 pm    
Reply with quote

You probably have what is called a "ground loop" hum. It could be the Evans preamp causing it or it could be the Lexicon. Try lifting the AC ground on the Evans preamp, using an AC ground lifting adapter.

That may take care of it. If it doesn't then you'll have to isolate the rack units, using "humfrees" mounting insulators. They're available from Musician's Friend and some music stores.

View user's profile Send private message Send e-mail

Kenneth Kotsay

 

From:
Davie/Ft Lauderdale, Florida
Post  Posted 21 Jan 2000 5:16 pm    
Reply with quote

Had the same hum/noise problem with my rack unit,(MACKIE POWER AMP 1400i,PEAVEY PROFEX II, TRANS/TUBEFEX & FURMAN POWER STRIP) I purchased a bag of "HUM FREES" at Mars Music store in Ft. Lauderdale, Florida. These plastic folding tabs isolate all the metal on each unit from the frame of the rack unit. After I installed them, presto no more hum.
View user's profile Send private message Send e-mail Visit poster's website

Blake Hawkins


From:
Florida
Post  Posted 23 Jan 2000 2:38 am    
Reply with quote

Dana, Are you putting the "wall wart" inside the rack case with the equipment?
Is the rig Ok with the wart outside of the rack case?
If so, then the problem is the magnetic field from the wart. The only remedy is to
leave the wart outside the case and to extend
the low voltage cable from it if it is too short.
If it hums with the wart away from the case, then you have a ground loop hum and the previous comments will correct that.
Blake

View user's profile Send private message Send e-mail

Jerry Roller


From:
Van Buren, Arkansas USA
Post  Posted 24 Jan 2000 7:01 pm    
Reply with quote

Dana, you need to make certain that the hum is not due to speaker wires coming in close contact with as AC line. Make sure you speaker wires are coming out from the rack in an area opposite where the AC line or lines are coming out.
View user's profile Send private message Visit poster's website


All times are GMT - 8 Hours
Jump to:  

Our Online Catalog
Strings, CDs, instruction,
steel guitars & accessories

www.SteelGuitarShopper.com

Please review our Forum Rules and Policies

Steel Guitar Forum LLC
PO Box 237
Mount Horeb, WI 53572 USA


Click Here to Send a Donation

Email admin@steelguitarforum.com for technical support.


BIAB Styles
Ray Price Shuffles for
Band-in-a-Box

by Jim Baron
HTTP