Author |
Topic: Changer tuning nut |
Ron Wendler
From: Southern Minnesota, USA
|
Posted 12 Apr 2024 7:36 am
|
|
I'm building a pedal steel and trying to make the Changer Tuning nuts but not going so well. I'm trying to thread 6-32 thread into the end of some 5/16" aluminum rod. No lathe. Is there a source to purchase these parts? _________________ A fine instrument is like a lady. Treat it nice and it will make lovely music. |
|
|
|
Jim Palenscar
From: Oceanside, Calif, USA
|
Posted 12 Apr 2024 7:47 am
|
|
Not sure you are wanting to do that- most of the time if it is for tuning adjustment a 40 pitch thread is used. If you're trying to drill a centered hole a lathe is required. I suppose you could drill a .136" hole in one side of a 1/2" metal block and then from the other side drill a 5/16" hole half way through using the .136 hole as your guide- that would get you close |
|
|
|
Ron Wendler
From: Southern Minnesota, USA
|
Posted 13 Apr 2024 4:52 am
|
|
I found what I need. _________________ A fine instrument is like a lady. Treat it nice and it will make lovely music. |
|
|
|
Steven Black
From: Gahanna, Ohio, USA
|
Posted 21 May 2024 9:28 am Tunning nuts for changer
|
|
try Granger.com |
|
|
|
Rich Cottle
From: Sacramento California
|
|
|
|
Tim Toberer
From: Nebraska, USA
|
Posted 22 May 2024 4:58 am Re: Pcb mounting posts
|
|
Rich Cottle wrote: |
https://www.ebay.com/itm/313619440018?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=xJZQsVTjQLO&sssrc=4429486&ssuid=&var=&widget_ver=artemis&media=COPY |
That's what I use. They work perfectly. |
|
|
|