| Author |
Topic: Legs too Small |
Robert Jackson
From:
Pennsylvania, USA
|
Posted 11 Oct 2017 6:09 pm |
|
I got there for a fender Custom pro T8 but they are too small...
Did fender make different size body attachments?
Any ideas fellas?
Bobby
 |
|
|
|
Robert Jackson
From:
Pennsylvania, USA
|
Posted 11 Oct 2017 6:09 pm Here are the body size
|
|
 |
|
|
|
Bill Sinclair
From:
Waynesboro, PA, USA
|
Posted 11 Oct 2017 6:59 pm
|
|
| I believe all Fender Custom Professionals and Stringmasters use a 3/4"-10 thread, which is huge. Someone just sent you the wrong size. |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 11 Oct 2017 7:35 pm
|
|
FWIW, the legs on my Dual Pro, 2 neck version use a 3/4" thread plug.
Assume your leg sockets have not been changed.... |
|
|
|
Jude Reinhardt
From:
Weaverville, NC
|
Posted 11 Oct 2017 8:14 pm
|
|
I believe some of the older fenders have a 1/2 X 13 tpi leg size.
Jude
_________________
"If we live in fear of banjos, then the banjos have won".
"Man cannot live by bread alone, he must have Peanut Butter". - Kruger Bear |
|
|
|
Bill Sinclair
From:
Waynesboro, PA, USA
|
Posted 11 Oct 2017 9:14 pm
|
|
| Jude Reinhardt wrote: |
I believe some of the older fenders have a 1/2 X 13 tpi leg size.
Jude |
Maybe, but none that I've seen. My limited sample of about a dozen 50's Fenders all had 3/4". |
|
|
|
Erv Niehaus
From:
Litchfield, MN, USA
|
Posted 12 Oct 2017 7:46 am
|
|
I'll tell you what I did.
I took a 3/4"x10 bolt, cut the threaded part off to the proper length, drilled out the center and tapped it to fit the thread on the legs like you have (1/2"x13). You can screw that onto the leg and epoxy it in place if you so desire and you are ready to go.  |
|
|
|
Ron Simpson
From:
Illinois, USA
|
Posted 12 Oct 2017 7:51 am
|
|
I have found that Atlas microphone stand make good replacement legs for Fender steel guitars.
The large diameter piece fits right into the guitar body piece, and the small diameter tube adjusts to the right height. A small rubber tip from the hardware store completes the project.
Ron |
|
|
|
L. Bogue Sandberg
From:
Chassell, Michigan, USA
|
|
|
|
Erv Niehaus
From:
Litchfield, MN, USA
|
Posted 13 Oct 2017 7:33 am
|
|
Yes, that should work.
Erv |
|
|
|
