| Author |
Topic: stringing a stringmaster |
Steven Meyrich
From:
Colorado, USA
|
Posted 10 Jul 2017 8:13 am |
|
Getting ready to restring my Fender T-8 string master and wonder about the best technique for stringing the tuner end? I have tried a few methods but would welcome the input of the experts here,
thanks,
Steve |
|
|
|
Jeff Mead
From:
London, England
|
Posted 10 Jul 2017 9:13 am
|
|
I usually trim the string so it is about 2 tuner lengths longer - so if it is string 8, it reaches to tuner 6 - (2 and a half or so on the highest strings).
Line up the tuner so the hole is vertical. Keeping the string slightly under tension with my right hand, I put the string through the hole in the tuner till it reaches the bottom of the tuner pan and wind it with a string winder. Once the tuner has gone a couple of turns and is holding the string firmly, I hold the string away from the fretboard and let it pull my finger down till it is flat. Tune to pitch and then give a little vertical tug so it goes flat and retune. Repeat a couple of times till it no longer goes flat. |
|
|
|
Tim Weaver
From:
Minnesota, USA
|
Posted 11 Jul 2017 4:37 pm
|
|
Thanks for the reply Jeff. Good call Steven, I was just going to ask this question.
Similar to a telecaster I have where the strings go into the center of the tuning peg. For that guitar I usually measure 2 strings longer than the string I'm putting on. |
|
|
|
Steven Meyrich
From:
Colorado, USA
|
Posted 12 Jul 2017 6:05 am
|
|
| Thanks Jeff! |
|
|
|
