| Author |
Topic: Derby mechanic |
Charlie Moore
From:
Deville, Louisiana, USA
|
Posted 5 Apr 2017 3:04 pm |
|
I need a Derby mechanic,to tell me how to get the cross shafts out of cabinet,thx
CM
_________________
Use it up,wear it out,make it do,or do without..... |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 5 Apr 2017 4:12 pm
|
|
Well, the pedal cross-shafts have a spring loaded pin in one end or the other, I forget which. You kind of have to work that pin back up inside the shaft for it to clear the bushing. Maybe a pocket screwdriver blade, or drill a small hole and work the pin back with a small pick.
Then, you have the center rail to deal with. Sometimes you can loosen up enough screws in it and/or remove enough parts to work the shaft out.
Or cut it in two if you aren't going to reuse it, but they're stainless steel...so.. |
|
|
|
Charlie Moore
From:
Deville, Louisiana, USA
|
Posted 6 Apr 2017 4:59 pm Derby
|
|
Thank you Jerry,I couldn't tell how they came out and I thought they had to come out like a Emmons,I got four wore out then I got to find some...CM
_________________
Use it up,wear it out,make it do,or do without..... |
|
|
|
Charlie Moore
From:
Deville, Louisiana, USA
|
Posted 15 Jun 2017 5:08 pm Derby part
|
|
Jerry,do you know where one could find the center angle piece that that guides the crossroads on a Derby.thanks..CM
_________________
Use it up,wear it out,make it do,or do without..... |
|
|
|
Jerry Overstreet
From:
Louisville Ky
|
Posted 15 Jun 2017 5:52 pm
|
|
| Maybe Billy Cooper. He used to service and sell Derby steels. |
|
|
|
