Author |
Topic: 3/16 Found Plz close THX |
Pat Moore
From: Virginia USA
|
Posted 22 Mar 2017 3:25 pm
|
|
Looking for self threading nylon tuners to work on my EMCI PSG. I really only need 2, but will buy more if available. These fit the smallest size threaded rods.
Stlll looking for the decal as well.
Thanks in advance,
Pat
Last edited by Pat Moore on 24 Mar 2017 8:12 am; edited 1 time in total |
|
|
|
Jerry Overstreet
From: Louisville Ky
|
Posted 22 Mar 2017 4:08 pm
|
|
http://www.psgparts.com/MCI-EMCI_c19.htm used to have them, but they show as not available now. You might contact Michael to see if he's just out of stock.
The rod size is 3/32" and the tuning nut length looks to be either 1 3/8 or 1 1/2 in. on my MCI. Sorry, I don't have any extras.
Carter nuts will probably fit. I think Al Brisco at SG Canada has those.
Emmons [.109 rod dia.] might work or Williams, but they're too short. Maybe use a spacer |
|
|
|
Pat Moore
From: Virginia USA
|
Posted 22 Mar 2017 4:18 pm
|
|
Thanks Jerry,
Yes, I went to Michael's site, as I had gotten some from him before, and saw where it said he was out of 'em.
I'll try and contact Al Brisco about the others. I hope they'll fit. Everything I've tried have been too big, but the one's I got from Michael were self threading.
Thanks for your input.
Pat |
|
|
|
Jerry Overstreet
From: Louisville Ky
|
Posted 22 Mar 2017 4:31 pm
|
|
I found some George L's that will fit your 3/32 rod size that I got from Williams, but they are just over 3/4" long. They are closed end and you would have to use a spacer with them for your EMCI though.
I would be happy to send you a couple of them if you think you can use them, or if you can't find others the correct length. |
|
|
|
Pat Moore
From: Virginia USA
|
Posted 22 Mar 2017 5:39 pm
|
|
Thanks Jerry,
I have the guitar apart right now, so I have a little time. I appreciate your offer.
If I can't find the others, I'll take you up on it. I'll let you know either way.
Thx again, Pat |
|
|
|
Jerry Roller
From: Van Buren, Arkansas USA
|
Posted 22 Mar 2017 7:49 pm
|
|
Jeff Surratt at Show Pro Guitars should have the ones you are looking for.
I believe they come as a package of 10.
Jerry _________________ http://www.littleoprey.org/ |
|
|
|
Larry Haas
From: Morganton, North Carolina USA
|
Posted 23 Mar 2017 12:43 am
|
|
I ordered some 1/8 tuners from Steel Guitar Network and Hank Ruf has the 3/32 ones in a pack of ten. They show as being closed end.
Larry |
|
|
|
Pat Moore
From: Virginia USA
|
Posted 23 Mar 2017 5:30 am
|
|
Thanks Jerry & Jerry, & Larry. I really do appreciate the input on finding these. Great place for hard to find parts!
Thx, Pat😄 |
|
|
|