Author |
Topic: Hipshot B-Bender with G arm raise and E st lower $65 |
Daniel McCombe
From: Pennsylvania, USA
|
Posted 26 May 2014 2:14 pm
|
|
I have a hipshot b bender system with the g arm arise and low E lower for guitar. It needs a wing nut to hold the b st hip attachment in place. Ive been using a srew and nut and it works just fine. $65 plus shipping to cont US |
|
|
|
Shaan Shirazi
From: Austin, TX, USA
|
Posted 28 May 2014 9:48 am
|
|
I'll take it! Just to make sure, it has B-raise full step, G-raise 1/2 step, and E-Lower full step correct?
Thanks! |
|
|
|
Jerry Hayes
From: Virginia Beach, Va.
|
Posted 29 May 2014 8:17 am
|
|
Hey Shaan, the vast majority of B and G bender players use the G raise as a whole step also. A half step on the G is a waste of the bender as you can do a half step with your finger along with the B bender and there is so much more you can do with a whole tone raise on the G and B.........JH in Va. _________________ Don't matter who's in Austin (or anywhere else) Ralph Mooney is still the king!!! |
|
|
|
Shaan Shirazi
From: Austin, TX, USA
|
Posted 3 Jun 2014 9:35 am
|
|
I never heard from Daniel after I emailed him directly. Hoping this reply works. |
|
|
|
John Reynolds
From: Iowa, USA
|
Posted 3 Jun 2014 10:41 am Bender
|
|
I emailed him right after he posted and have had no reply |
|
|
|
Daniel McCombe
From: Pennsylvania, USA
|
Posted 6 Jun 2014 11:08 am forum emails not going through
|
|
Hey everyone I apologize but i never recieved your emails. The forum is having problems with emails not going through. If you are still interested PM me and we can make arrangements. _________________ Fessy sd-10 lil' izzy Mesa nomad 55 fender mustang 2x12 |
|
|
|
John Reynolds
From: Iowa, USA
|
Posted 8 Jun 2014 4:17 am Bender
|
|
PM sent |
|
|
|
John Reynolds
From: Iowa, USA
|
Posted 13 Jun 2014 5:06 am Bender
|
|
Going to try this 1 more time then @#$% !!! |
|
|
|
Shaan Shirazi
From: Austin, TX, USA
|
Posted 13 Jun 2014 7:47 am
|
|
Hey John, I actually purchased the Hipshot and it arrived for me yesterday. If for some reason it doesn't work out I'll probably sell it here in the future. |
|
|
|
John Reynolds
From: Iowa, USA
|
Posted 13 Jun 2014 7:53 am Bender
|
|
I hope it works out for you, if not contact me, I may still be interested if I don't just buy a new one.. |
|
|
|