| Author |
Topic: mike |
Lavelle Pierce
From:
huntsvile,ar 72740
|
Posted 17 Dec 2008 7:55 pm |
|
| can i use a mike on a nashville 400 and how to plug it on?thanks |
|
|
|
Mike Perlowin
From:
Los Angeles CA
|
Posted 18 Dec 2008 3:54 am
|
|
It can be done, but it won't sound very good. Instrument amps are not designed to handle voices.
You would need to get an adapter from the XLR plug to a 1/4 inch one.
_________________
Please visit my web site and Soundcloud page and listen to the music posted there.
http://www.mikeperlowin.com http://soundcloud.com/mike-perlowin |
|
|
|
Jim Sliff
From:
Lawndale California, USA
|
Posted 18 Dec 2008 8:25 pm
|
|
| Quote: |
| You would need to get an adapter from the XLR plug to a 1/4 inch one. |
Unless it's a high-impedance mic...
But before making any recommendations - what exactly are you trying to do? Amplify voices or acoustic instruments through your amp? Without knowing the application it's hard to tell what might work - although Mike is correct, it's usually just a bad idea.
_________________
No chops, but great tone
1930's/40's Rickenbacher/Rickenbacker 6&8 string lap steels
1921 Weissenborn Style 2; Hilo&Schireson hollownecks
Appalachian, Regal & Dobro squarenecks
1959 Fender 400 9+2 B6;1960's Fender 800 3+3+2; 1948 Fender Dual-8 Professional |
|
|
|
b0b
From:
Cloverdale, CA, USA
|
|
|
|
Stephen Gambrell
From:
Over there
|
Posted 19 Dec 2008 4:48 am
|
|
| What Sliff said---Are you trying to use the amp for a P.A., or are you trying to put a mike in front of the amp? |
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 19 Dec 2008 9:22 am Nashville 400
|
|
| You can obtain a preamp signal by simply connecting an instrument cable from the PRE AMP OUT on the rear panel. No XLR connector involved. This will access a nominal one volt signal from the PRE AMP OUT jack. |
|
|
|
Lavelle Pierce
From:
huntsvile,ar 72740
|
Posted 21 Dec 2008 7:16 am Re: Nashville 400
|
|
| Mike Brown wrote: |
| You can obtain a preamp signal by simply connecting an instrument cable from the PRE AMP OUT on the rear panel. No XLR connector involved. This will access a nominal one volt signal from the PRE AMP OUT jack. |
mike if you use the mike far singing how can you ajust the volume? |
|
|
|
